Leather punching machine is one of the indispensable and important equipment in various processing enterprises, especially widely used in the stainless steel pipe industry. Although the leather punching machine is safe and easy to operate, it is still necessary to pay attention to standardized operating principles during use in order to reduce the occurrence of unexpected failures. Below, Dayu Machinery Manufacturing Factory in Yayao Town, Heshan City has collected safety principles for using leather punching machines:

1. Comprehensive debugging and inspection of equipment before operation

Checking the equipment before using a leather punching machine for punching operations is a necessary task. To ensure that the equipment can meet the safety requirements during the production process. Mainly check whether each circuit is normal and whether the grounding wire is properly connected. All installed molds and fixing bolts should be tightened with screws, and a simple machine test should be conducted before operation to adjust the operating speed of the equipment. The speed needs to be adjusted according to the actual processing requirements and the degree of adaptability of the operation work.

Step 2: Use safety protection devices during operation

When operating a leather punching machine, it is important to use appropriate protective equipment, such as wearing protective clothing or gloves, to avoid safety accidents caused by steel pipe debris splashing during rapid processing. In addition, when wearing gloves, be careful not to check for long thread ends to prevent the high-speed leather punching machine from winding the glove thread ends into the equipment and causing personal injury. And do not place items such as wires or ropes on the operating table. Additionally, it should be noted that in the event of a "strike" of the equipment during operation, the operator should not dismantle or repair it without authorization, in order to avoid self injury caused by improper operation and even greater equipment failure.

Step 3: Disassembly after operation should be standardized

After using the leather punching machine, it is important to pay attention to all finishing work, as the machine is surrounded by debris after prolonged operation. A comprehensive "bath" is necessary to ensure a better working condition when operating the equipment again next time. Be sure to pay attention to standardization during this step of operation. Firstly, it is necessary to turn off the power while the equipment is shut down before proceeding, and specific operations must be carried out after the mold head has cooled down. The mold head, which has just finished working, is in a very high temperature state and may burn hands. When disassembling the mold and clamping tools, be careful not to use hammers or hard objects to strike. It is best to wear canvas gloves for operation to avoid sharp mold head injuries.

From the above introduction, it can be seen that the leather punching machine needs to pay attention to safety operation principles at different stages of operation, so as to minimize major failures and ensure high safety throughout the entire equipment operation. At the same time, different enterprises can also constrain their workers with these three safety principles to meet the safety requirements at different stages of operation. Of course, the prerequisite is to first purchase high-performance leather punching machines, so as to ensure that the precision components of the equipment are of high quality and will not have problems, and to improve safety and productivity.

The article is from Jiangmen Leather Punching Machine:http://www.hslichuang.com/